www.easy2access.net
Easy2Access A/S
®
EASY-908 Pin Code lock
25
seconds.
Enter
#1 + a master PIN code + #
(with the Green LED blinking)
+ 0
to
get the lock back to Automatic Locking Mode. When the Green LED blinks
again and one long beep is heard, the lock gets back into Automatic Locking
Mode, and user cannot unlock from outside before one correct PIN code is
entered.
Example: #1123#0
▲
The original factory set mode is Automatic Locking Mode.
Anti-Malicious Operation Setup
Enter #2 + a master PIN code + #
(with the Green LED blinking)
+ 1
to
trigger Anti Malicious Operation functionality.
When the Green LED blinks
again and a long beep is heard, this functionality is triggered.
Enter #2 + a master PIN code + #
(with the Green LED blinking)
+ 0
to
cancel this functionality.
When the Green LED blinks, this functionality
ceases to work.
▲
Important Note:
When this functionality is applied, any wrong PIN code
access attempts on five consecutive occasions will immobilize the lock for
5 minutes. During this period, any button on the outside unit will cease to
function.
7.
Unlocking from the Outside Unit
Opening the lock with a pin code
The power button on the outside unit is used to trigger the night-view light
beneath the PIN code keypad. This night-view light will last 3 seconds with
no operation following, but will not turn off until any operation on the keypad
is accomplished.
Fully lift up the outside sliding cover and directly enter one existing outside
PIN code + # (or + *, or + the power button). The door can be opened after
the motor is done operating (the motor makes a small sound while
operating). Be aware that several attempts opening the door while the
motor is operating can damage the motor. Meanwhile disarming; the lock
