Eastwood Elite 64646, Assembly And Operating Instructions Manual

Page: 13 / 16

To order parts and supplies: 800.343.9353 >> eastwood.com
13
FIG. 25 FIG. 25
• Remove the two Wheel Yoke Mounting Screws. Note the other set of holes in the
Wheel Yoke Mount Tube
(FIG 25)
. The Wheel Yoke can now be indexed 90° and
remounted. When tightening the screws visually square up the Wheel Yoke with
the Wheel Yoke Tube and Frame
(FIG 26)
.
• Carefully reinstall the Wheel and Axle with a spacer at both sides. The easiest
way to accomplish this is:
- Insert the Axle and place one of the spacers over it (FIG 27) .
- Carefully, as not to knock the spacer off, maneuver the Wheel into position
and push the Axle through the two bearings
(FIG 28)
.
- Make sure the Axle is not protruding from the second bearing so that the
spacer can still be installed.
- Insert the spacer and push it all the way in (FIG 29) . Now, with a small
screwdriver, draw it into alignment (FIG 30) and push the Axle through
completely.
- Reinstall the snap ring.
FIG. 26 FIG. 26
FIG. 27 FIG. 27
FIG. 28 FIG. 28 FIG. 29 FIG. 29 FIG. 30 FIG. 30