To order parts and supplies: 800.343.9353 >> eastwood.com
7
MAINTENANCE
CHECK/ADD HYDRAULIC FLUID TO PUMP
• Check that the Release Valve
(FIG 10,
Knob located at the Lower Front side of the Hydraulic Pump
)
is closed.
(Rotate in a Clockwise direction)
• Remove Oil Fill Screw at top of Pump.
NOTE:
Do Not lose Seal Ring.
• The fluid level should be visible at the bottom of the threads. If required, add a high-quality hydraulic fluid.
• Check that the Seal Ring is in place on the Fill Screw/Breather and thread the Fill Screw into the Pump securely.
STORAGE
• Keep in a clean, dry area free of corrosive moisture wit Ram in the retracted position. Covering with thick plastic is recommended.
TROUBLESHOOTING
PROBLEM
CAUSE
CORRECTION
Ram Stops
Before Full
Work Stroke is
Completed
Low fluid level in Reservoir
Retract Ram fully and check fluid level. Add a high quality, hydraulic oil as
needed.
Offset forces causing binding of
components
Retract Ram and check thoroughly for any offset forces acting on components.
Pushing Capability of the Ram has
been exceeded
Retract Ram and discontinue use.