10
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
11.
Install Latches (M) to the upper corners of the Cabinet Front
Panel (H) and secure with four M4 x 10mm screws (CC), flat
washers, (GG) & nuts (FF)
(FIG. 17)
.
12.
Peel away protective paper and apply Sealing Foam (KK) on the
exposed level flange areas on the top of the Cabinet Side Panels
(E) and (I) and along the top edge of the Cabinet Back Panel (C)
(FIG. 18)
.
NOTE:
Be sure that no gaps exist between sections of
sealing foam.
13.
Snap LED Lamp (QQ) into Lamp Clips
(FIG. 19)
.
14.
Route the cord of the LED Lamp (QQ) through the hole in the
upper area of Cabinet Side Panel (E) then thread the cord ferrule
into the hole
(FIG. 19)
.
15.
Bolt down Box Top Panel with eleven M6 x 12 screws and nuts.
16.
Connect the LED Lamp (QQ) wires to the Switch (F) wires. At-
tach Blue Wire to Blue wire connection and Brown Wire to the
Gray wire connection
(FIG. 19)
.
NOTE:
Needle Nose pliers may
be useful for inserting wires to switch connection.
17.
Attach Switch (F) to Cabinet Side Panel (E) with two M4 x 10mm
screws (CC), washers (GG) and nuts (FF)
(FIG. 19)
.
NOTE:
Be
sure to position the switch facing forward towards operator.
18.
Peel away protective paper and apply
Thick
Sealing Foam (JJ)
on the remaining exposed angled flange areas on the opening
of the Cabinet Assembly
(FIG. 20)
.
NOTE:
Be sure that no gaps
exist between sections of sealing foam.
19.
Attach Door (A) hinge plate to the Cabinet Top (D) with six M6 x
12mm screws (AA) and nuts (EE)
(FIG. 20)
.
NOTE:
Do not let door
fall backward against top or glass window breakage will result.
FIG. 18
FIG. 19
FIG. 20
E
KK
C
I
AA
FF
TT
D
GG
FF
F
CC
E
JJ
JJ
JJ
JJ
I
H
E
2 Pcs. CC M4 x 10mm Screw
2 Pcs. GG M4 Washers
2 Pcs. FF M4 Nut
6 Pcs. AA M6 x 12mm Screw
6 Pcs. EE M6 Nut
blue wire
blue wire
gray wire
brown wire
Lamp Wire
Connection