Eastey EXS-100, User Manual

Page: 15 / 53

Installation 15
2. Height of nearby packing equipment feeding into or receiving product from the
strapping machine. The EXS-100 Semi-Automatic Strapping Machine is pre-
configured to 30.7 in. (78cm) standard height.
3. Alignment with packaging line.
4. Allow for a clear area of approximately 19.7 inches (50mm) minimum from the
front (operator’s side) for the length of the machine for the operator, and 20
inches (50mm) minimum from the right side for the width of the strapping
machine for packages. See the Dimensions diagram in the Introduction of this
User Guide.
The strapping machine should be placed on a flat, level floor and the locking casters
locked so that it does not rock or move.
Assembling Stop Angle Brackets to Top Work Surface
The package provided with the User Guide and stop angle brackets contains four each
of wing bolts, flat washers, and lock washers. Placing the flat washers above the slot
holes in the stop angle brackets and placing the lock washers above the flat washers,
next to the wing bolt head, fasten the stop angle brackets to the strapper top work
surface as shown.
Stop
Angle
Brackets
Wing Screws
Lock Washers
Flat Washers