18 Operation
Manual Feed
Use this button to manually feed strapping material. Strapping material will be
fed out for as long as the button is pressed. Release the button to stop
feeding material.
Reset
The Reset button allows you to reset the strapper, expelling the strapping
material in the current job and cutting it off in order to begin with a freshly cut
strap end.
Operating the Machine and Strapping Packages
1. To begin operation, turn the Main Power Switch to the On position. The heating
element requires approximately 1 minute to reach operating temperature.
CAUTION!
When the power is turned on keep hands and arms of the
tabletop, which may become hot from the heating element.
Keep hands and arms clear of the area where the strap will
be applied to the package.
2. Place a package on the top flat work surface. (The package must cover the table
slot.) Slide the package tight against the angle stop brackets.
3. Adjust the strap tension the desired strap tension and strap feed length for the
package size.
Note:
Setting the feed length may take some trial-and-error to
attain the right adjustment each time setup for a different
carton or package size is required.
Summary of Contents for EXS-100
