Page: 17
p
62. Repeat for the remainder of the
surfaces.
p
63. Locate 2 "L" bend linkages, the 2
straight wire linkages & the 2 carbon fiber
tube pushrod mid sections.
p
64. Roughen the wire with sand paper and
glue one end into the carbon tube as shown.
Wrapping the glue joint with thread and
glue can add strength to the joint.
p
65. Depending on where you cut in your
elev. & rud. servos, you may have to trim
the carbon fiber tube down a bit in length.
p
66. 2 completed tail section pushrods:
