Unscrew the aluminium nut from the end of the casing.
Place the rubber o-ring on the open end of the quartz
sleeve, approximately 2cm from the end.
Gently insert the quartz sleeve into the casing. Replace
the aluminium nut and tighten.
THIS NUT SHOULD BE HAND TIGHT. DO NOT
OVERTIGHTEN
Now connect the lamp to the socket.
DO NOT TOUCH
THE LAMP WITH BARE HANDS AS THIS WILL
AFFECT THE PERFORMANCE OF THE LAMP.
Connect by gently pushing the four pins of the lamp into
the socket.
Gently position the lamp into the quartz sleeve through
the open end of the stainless steel casing.
Push on the rubber cap/seal and ensure that it is sitting
correctly with no creases or kinks.
2
3
4
6
1
2
3
4
5 & 6
Page 3
1
5
Now refer back to page 2 for next steps
UV 3.9 LPM SYSTEMS