16
Attention: There are blocks between the front cover and back frame.
Tool: a plus screwdriver
6. Replacement of the kneading, tapping and rolling motors
Attention:
The voltage of this massage chair is high and the motors are rotating in high speed, so make
sure the power is OFF before disassembly. For safety, you should remove plug from outlet.
6.1 Kneading motor
（
DC -24V
）
①
Disassemble the rear cover of the back rest,
and find the belt at top of the massage mechanism,
then loosen the belt.
②
Find the wire of kneading motor, and cut
the cable ties tightening the wire with wire cutters.
③
Remove the close-end wire connectors covering the wires with
nipper pliers, then disconnect the wires.
④
Find 4 pieces of screws fixing the kneading motor to the sheet-metal,
remove the screws with a plus screwdriver.
⑤
Replace a new one if it does work.
⑥
Proceed in the reverse order of disassembly when replacing a new one.
Note
：
You should adjust the position of the small belt wheel, so the small and big belt wheels are in the
same plane to prolong the life-span of the belt.
Kneading motor
Cut the cable ties and remove
close-end wire connector
Tools
Screws fastening the front
cover to the back frame (6
PCS)
Summary of Contents for EC-380B
Page 3: ...3 I Specifications...
Page 31: ......
Page 34: ...3 5V 1 GND 2 PTE6 I O 3 PTE5 I O 4 PTE4 I O 5 PTE3 I O J26 6 5V TJC3S 6A...
