board is damaged.
power board.
The display board is
damaged.
Replace the display
board.
Some buttons can’t work,
or the LED display is not
normal.
The display board is
damaged.
Replace the display
board.
The
Cooking
Mode
Indicator comes on, but
heating does not start.
High temperature of
the hob.
Ambient
temperature
may be too high. Air
Intake or Air Vent may
be blocked.
There is something
wrong with the fan.
Check whether the fan
runs
smoothly
；
if not , replace the fan.
The power board is
damaged.
Replace the power board.
Heating stops suddenly
during operation and the
display flashes “u”.
Pan Type is wrong.
Use the proper pot (refer
to
the
instruction
manual.)
Pan
detection
circuit is damaged,
replace the power
board.
Pot diameter is
too small.
Cooker has overheated; Unit is overheated. Wait
for temperature to return
to normal.
Push “ON/OFF” button to
restart unit.
Heating zones of the same
side (Such as the first and
the second zone) would
display “u” .
The power board and
the display board
connected failure;
Check the connection.
The display board of
communicate part is
damaged.
Replace
the
display board.
The Main board is
damaged.
Replace the power board.
Fan motor sounds
abnormal.
The fan motor is
damaged.
Replace the fan.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing. For the purpose of installation
and use, a minimum of 5 cm space shall be preserved around the hole. Be sure the thickness of the
work surface is at least 30mm. Please select heat-resistant and insulated work surface material (Wood
and similar fibrous or hygroscopic material shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from
the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces
of
the worktop
should be at least 3mm.
V.2
21
Summary of Contents for EMIH600-FX1
Page 107: ...V 2 ...
