70
Please close the hydrant after using.
POSITIONING THE APPLIANCE
Position the appliance in the desired location. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or walls. The dishwasher
is equipped with water supply and drain hoses that can be positioned either to
the right or the left sides to facilitate proper installation.
HOW TO DRAIN EXCESS WATER FROM HOSES
If the sink is 1000 higher from the floor, the excess water in hoses cannot be
drained directly into the sink. It will be necessary to drain excess water from into
a bowl or suitable container that is held outside and lower than the sink.
WATER OUTLET
Connect the water drain hose. The drain hose must be correctly fitted to avoid
water leaks. Ensure that the water inlet hose is not kinked or squashed.
EXTENSION HOSE
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 meters; otherwise the cleaning effect of the
dishwasher could be reduced.
SYPHON CONNECTION
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it
run into the sink, making sure to avoid bending or crimping it. The top of the hose
must be less than 1000mm.
8.5
Start of dishwasher
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. Inlet hose connections are fully tightened and not leaking.
4. The wires are tightly connected.
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packaging materials and printings should be taken out from the
dishwasher.
Attention: After installation, please make sure to keep this manual. The content
of this manual is very helpful to the users.
V.1
