WARNING:
Before carrying out maintenance operations, disconnect power supply.
Before each use
check the extension cord for
signs of damage or ageing. Replace the cable if it is
cracked, split or otherwise damaged. Check the
condition of the tines and ensure that all threaded
connections are securely tightened. If the tines
become dull or blunt, sharpen or replace them. Call
our customer service help line at 1
-
800
-
313
-
5111 for
assistance.
At the end of the season, check the tiller/cultivator for
damage prior to storing. Repair or replace damaged
or broken parts.
CAUTION:
Always clean the tiller/cultivator after
each use. Failure to carry out proper cleaning can
result in damage to the tiller/cultivator or result in
poor performance.
Clean the tines with a scrub brush, and a soft cloth
dampened with a mild soap and water mixture.
Never use a water hose to clean the tiller!
To
remove soil and debris from the tines, use a stiff
brush or a dampened cloth. Clean the vents on the
motor housing and remove any remaining grass or
dirt. Once cleaned, wipe the tines dry and apply a
light coat of oil to prevent rust.
WARNING:
Injury can occur while working on the
tines. Wear protective gloves.
Tines maintenance:
Worn tines invite poor
performance and overload of the motor. Check tines
before each use. Sharpen or replace the tine
assemblies with new ones when necessary. Call 1
-
800
-
313
-
5111 for assistance.
Tine Replacement
Tines are identified with part number JY2201
-
1 or
JY2201
-
2 stamped on the tine blade.
Replace only the tines with the identical part
number.
Tine Removal
(Fig. 7)
1. Remove the M8 hex locknut with a hex head
wrench, and then remove the M8x170 bolt.
2. Remove the end caps.
3. Remove the tines and hubs at either end of the
shaft.
Tine Installation
(Fig. 7)
1. Install the new tine by pressing it onto the hub. The
side with stamped part number must face outward. Be
sure to install tines in the same sequence as shown in
Fig 7. Position the hub so that the larger diameter
whole is facing outward. Make sure the two tines on
the same hub are installed symmetrically with the end
of the tine blades facing downward (Fig. 8).
2. Install the tines with hub onto the shaft. Ensure the
larger diameter whole of the hub is facing outward.
The left and right tine assemblies must be installed
symmetrically (Fig. 8).
3. Install the end caps.
4. Install the M8x170 bolt. Secure the assembly by
tightening the M8 hex locknut with a hex head wrench.
Replace worn or damaged parts with original
replacement parts only. Parts from another tiller/
cultivator may not fit properly causing an unsafe
situation.
Make sure all protective devices are secure and in
good condition. Repair or replace if necessary.
9
MAINTENANCE
Tine P/N
JY2201
-
1
Tine P/N
JY2201
-
2
Tine P/N
JY2201
-
1
Tine P/N
JY2201
-
2
Hub
Hub
End Cap
End Cap
M8x170
Bolt
M8 Hex Locknut
Bushing
Bushing
Symmetrically
installed tine blades
facing downward
Larger diameter
whole of the hub
facing outward
Shaft
7
8
