Assembly Instructions
M52126_6500_Cultivator
PAGE 3
ASSEMBLY OF TOOLS
(see right)
FURROW PLOW
Place Furrow Plow in front of tool support slot. Put hex
bolt (#19) through square hole in the plow and through
slot in tool support. Next put formed washer (#20) over
carriage bolt (#19) and tool support: fasten with lock nut
(#18) and tighten fully.
HILLING / MOLD BOARD PLOW
Place Hilling Plow in position shown above. Put carriage
bolt (#19) through square hole and through slot in tool
support. Next put formed washer (#20) over hex bolt
(#19) and tool support: fasten with lock nut (#18) and
tighten fully.
MULTI-TINE ADJUSTABLE CULTIVATOR
Assemble Multi-Tine as pictured above. Put carriage bolt
(#19) through rear of the mounting plate (#28) and
through tool support and then the formed washer (#20)
and fasten with lock nut (#18), tighten fully. Next, attach
the tines (#27) with bolt (#24) through flat washer (#25) and secure with hex nut (#26), leave loose until you determine
tine width as required. Tighten fully.
6502 Parts List
KEY
DESCRIPTION
QTY
A
Left Tool Support
1
B
Right Tool Support
1
C
Wood Handle
2
D
Hardware Package
1
6502 Optional Wood Handle Kit
C
A
B
D
