Assembly Instructions
M52126_6500_Cultivator
PAGE 2
ASSEMBLY HARDWARE
ASSEMBLY INSTRUCTIONS
1. Assemble both (#4) Upper and (#3) Lower Handles together and secure with (#12) hex bolt & (#15) hex nut
– do
not tighten.
2. Assemble (#7) Left and
(#6) Right Tool Supports,
by positioning (#9) Tool
Support Spacer between
them at the end that has
only one hole as shown in
the exploded view, secure
using (#11) hex bolt and
(#15) hex nut and tighten.
Make sure you have the
Right and Left in the
correct position as shown
in the exploded view.
3. Connect (#2) Frame to
the Tool Support
Assembly from step 2
using (#14) hex bolt thru
the (#2) Frame and then
through both (#6 & #7) Tool Supports, then through (2) Frame on the other side and secure with (#16) lock nut,
and tighten.
4.
Install (#8) Cross Brace on to the Upper Handle and secure with (#10) hex bolt and (#16) lock nut to each side,
loosely tighten.
5.
Install (#5) Axle into (#23) Wheel and position between the (#2) Frame rails.
6.
Now insert (#13) hex bolt through the hole in (#3) Lower Handle, (#2) Frame, then into (#5) Axle & (#23) Wheel,
then (#2) Frame, (#3) Lower Handle and secure with (#17) Lock Washer & (#15) hex nut, and tighten.
7.
Now determine a comfortable operation height and then remove (#15) hex nut and select one of the four
adjustment holes in the top of (#6 & #7) Tool Supports and secure with (#15) hex nut and tighten.
(1) #13
HHCS
(2) #10
HHCS
(1) #11
HHCS
(2) #12
HHCS
(1) #14
HHCS
(1) #19
CARRIAGE
BOLT
(5) #24
HHCS
(3) #16
Lock Nut
(5) #25
Washer
(4) #15
Hex Nut
(1) #18
Lock Nut
(1) #17 Lock
Washer
(5) #26
Flanged Hex
Nut