Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
Control Panel Overview continued
MAIN POWER switch must be ON for this
(7) Low Level RCA Inputs
feature to work.
This the best way to drive audio signal to the
MiniMe FF8
V2
.
(10) Main Power Switch
When switched OFF, the amplifier will remain
NOTE:
off as there is no AC power being fed into it.
DO NOT USE HIGH LEVEL AND
We highly recommend keeping this switch
OFF when the subwoofer is not being used for
LOW LEVEL INPUTS AT THE
an extended period of time.
SAME TIME
(11) AC Power with Built-in Fuse
(8) LFE/SUB Operation Mode Switch
This AC line connector is fused to protect the
When the switch is in LFE position, the
subwoofer from unwanted power surges. Be
subwoofer is running in full range mode (20Hz -
sure to use the proper fuse rating when
2kHz) and the frequency adjustment is
replacing the fuse:
disabled. When the switch is in SUB position,
110-120V~60Hz: ø5x20mm, T3.15AL/250V
the subwoofer reverts to manual frequency
220-240V~50Hz: ø5x20mm, T1.6AL/250V
adjustment, allowing the user to operate and
fine tune the subwoofer to his/her preference.
(9) AUTO/ON/OFF Switch
This is a 3-way switch. When ON, the amplifier
will remain on regardless of signal presence.
When set to AUTO, the amplifier will only turn
on when audio signal is detected. Additionally,
the amplifier will go to sleep/stand-by if it does
not detect any signal after 15 minutes. When
set to OFF, the amplifier will remain off
regardless of signal presence. Note that the
To access the fuse compartment, simply
unplug the subwoofer from any power source,
place a flat-head screw driver in the small
notch and pry it open as illustrated below.
(10)
(11)
(7)
(8)
(9)
8 MiniMe
Manual
P8
V2
/P8W
V2
