10 MiniMe FF8
V2
Manual
Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
Connecting Your Subwoofer(s)
Low Level Setup - Single Sub
This is the best way to drive an audio signal into the
MiniMe P8
V2
/P8W
V2
. Today, all signal processors
(5.1/6.1 and more advanced ones) come equipped
with built-in pre-amplifier outputs (RCA) that include a
subwoofer output. Generally, the SUB PRE OUT is in
mono format. Connect the SUB PRE OUT from the
processor/receiver to the MiniMe P8
V2
/P8W
V2
’s LOW
LEVEL INPUT using a “Y” RCA cable.
We strongly recommend that you use the best
available RCA connectors and cables. High quality
cables are normally triple shielded and the
connectors are gold plated with forceful grasping.
When using this connection, the MiniMe P8
V2
/P8W
V2
only receives bass signals from the source.
Therefore, the crossover frequency should be set at
max value.
Low Level Setup - Dual Sub
For a more realistic sound stage and greater theater
experience, we suggest having two (2) subwoofers
and running them in stereo.
Using a “Y” RCA cable, connect the SUB PRE OUT 1
of the receiver to the LOW LEVEL INPUT of the left
side MiniMe P8
V2
/P8W
V2
.
Using another “Y” RCA cable, connect the SUB PRE
OUT 1 of the receiver to the LOW LEVEL INPUT of
the right side MiniMe P8
V2
/P8W
V2
.
In case the subwoofers become out of phase with the
main front speakers, adjust the phase shift to correct
the problem. Note that maximum bass is only
achieved when the sub is in phase with the speakers
in your system.
back of typical
processor/receiver
back of typical
processor/receiver
SUR. BACK
CENTER
FRONT
SURROUND
PRE OUT (SINGLE)
SUB
SUR. BACK
CENTER
FRONT
SURROUND
PRE OUT (SINGLE)
SUB
NOTE:
DO NOT USE HIGH LEVEL AND LOW
LEVEL INPUTS AT THE SAME TIME