17
I
O
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result causing
property damage, personal injury or loss of life.
A.
This appliance is equipped with an ignition device that automatically lights the pilot. DO NOT attempt to
light the pilot by hand.
B. BEFORE OPERATING,
smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fi re department.
C.
Use only the control system or remote to light the pilot. This valve will not operate if the pilot is not lit and
stable.
D.
Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fi re or explosion resulting in property damage, personal
injury or loss of life.
ON
OFF
HI
LOW
Fig. 17-3
Remote transmitter detail
HI-LOW
fl ame
adjustment
buttons
ON
button
OFF
button
Signal
light
REMOTE LIGHTING
CAUTION:
DO NOT attempt to light the pilot by hand.
Note:
If the remote does not function, and batteries with an
adequate power level are installed, refer to the SYNCING
THE REMOTE section.
Note:
Steps 1 and 2 may not be required if previously done
during an earlier lighting.
1.
Locate the ON/OFF switch at the front of the switch box. Press
the switch to the
OFF (O)
position. See Fig. 17-1.
2.
Locate the OFF/REMOTE slide actuator on the left rear of
the burner. Slide the actuator to the right /
REMOTE
position.
See Fig. 17-2.
3.
Locate the remote transmitter and press the
ON
button (see
Fig. 17-3). The system will beep and the ignition sequence
will begin.
The igniter will begin to spark. After the pilot lights and
is established, the valve will automatically open and the
burner will light. Adjust to the desired setting with the remote
transmitter. See the REMOTE OPERATING INSTRUCTIONS
section for details.
Note:
The ignition sequence will take approximately 5 seconds.
WARNING: If pilot fails to light within 10 seconds, press the
OFF button on the remote transmitter or slide the
OFF/REMOTE slide actuator (left) to OFF to turn
off the system. Allow fi ve (5) minutes for any gas
in the unit to dissipate, then repeat steps 2 & 3
above. IF YOU SMELL GAS, SEE STEP B ABOVE.
If the pilot fails to light after several tries, turn all control/remote
system components to
OFF
and contact a qualifi ed professional
service technician.
Fig. 17-2
OFF/
REMOTE
slide actuator (left rear of burner)
ON
Fig. 17-1
Switch box, ON/
OFF
OFF
Remote receiver