15
INSTALLING/REPLACING BATTERIES
CAUTION:
Ensure the unit is connected to the gas line and has
been tested for leaks before you insert batteries.
CAUTION:
Turn off the remote and/or burner and allow the unit
to completely cool prior to any battery replacements.
Important:
Prior to inserting batteries, always apply a small
amount of dielectric grease to both ends of each
battery. This will ensure conductivity and prevent
moisture from affecting the contact.
Important: Low/dead batteries will affect burner system
operation. Replace batteries any time the burner
will not turn on.
REMOTE TRANSMITTER BATTERY
The remote transmitter requires one 12V battery to operate
(included). Locate the transmitter, remove the lid (found on rear),
and properly insert the new battery as marked. Re-secure the lid.
See Fig. 15-1.
SWITCH BOX BATTERIES
Important:
Always replace the decorative heat shield over the
switch box after battery replacement.
The burner system requires 4 AA batteries to operate (included).
Locate the switch box and turn it over. Detach the battery box from
the Velcro. Use a small Phillips screwdriver to remove the screw
found on the bottom of the battery box, then remove the battery lid.
Properly insert the new batteries as marked. See Fig. 15-2.
Replace the battery lid using the screw, replace the battery box
onto the Velcro, and re-position the switch box in the fi replace.
Fig. 15-1
Transmitter battery
Remove
lid for
12V
battery
access
Fig. 15-2
Switch box batteries
AA batteries
