background image

1) SAFETY OPERATING INSTRUCTIONS

PLEASE READ BEFORE USE

• Never under any circumstances aim the gun at a person or animal. In the event of an accident, seek expert

medical advice immediately.

• The spray gun must only be used with paints and solvents that have a flash point suitable for spraying. If in

doubt, consult the paint or solvent manufacturer’s instructions.

• Always ensure there is adequate ventilation in the room when spraying.

• NEVER spray near a naked flame, including a pilot light.

• NEVER smoke whilst spraying.

• NEVER let children use or play with the spray station.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.

• Always read the solvent manufacturer’s instructions before use.

• Always disconnect the spray station from the mains supply when filling the paint container.

• Always disconnect the spray station from the mains supply before cleaning the appliance.

• Always wear a suitable protective mask when spraying. We would also recommend the use of suitable gloves,

goggles and a coverall.

• After each use, thoroughly clean the spray gun and grease the needle.

• Use only genuine manufacturer replacement parts.

• Wear ear protection.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a hazard

WARNING: The substances used with this spray gun (paints, solvents, etc.) may contain dangerous, harmful, explosive
or corrosive materials. ALWAYS COMPLY WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND
THE MATERIAL BEING USED.

Only use the spray station as described in this manual.

TECHNICAL SPECIFICATION

Wattage: 650 Watts

Container capacity: 0.9 litres

Voltage: 230 V

Air hose length: 4 m

Air output: 131/s

Dynamic air pressure: 0.14 bar

Sound pressure level: 80dB(4)

Maximum viscosity: 120DIN/sec

2

Summary of Contents for HV4900










Reviews: