8
Earlex Ltd., Opus Park, Moorfield Road, Guildford, Surrey. GU1 1SZ.
Tel
: +44 (0) 1483 454666.
Fax
: +44 (0) 1483 454548.
email:
www.earlex.co.uk
©
2008 Earlex Ltd.
WD0046 04/08
MAINS CONNECTION
This unit is a Class II appliance which means it is double insulated for your protection, no earthing wire is
necessary.
If the supply cord is damaged, it must be replaced by Earlex Ltd or our appointed agents.
Your unit has been supplied with a mains lead with a fitted plug. This is identified by the fuse holder in the
base of the plug. Please read the following safety instructions before use.
1. If the fitted plug is cut off from the mains lead then the plug must be disposed of safely.
NEVER
under any circumstances insert such a plug into a 13 amp socket.
2.
NEVER
under any circumstances use the appliance or mains lead without the fuse cover fitted.
This is the little cover fixed into the base of the plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our
helpline.
4. A replacement fuse must be rated at 13 amp. These must be manufactured and approved to BS 1362.
5.
IF IN ANY DOUBT CONTACT AN ELECTRICIAN.
If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring
instructions below, and will need to be used with a 13 amp fuse. If in doubt consult an electrician.
If you are using an extension lead it must be rated at a minimum of 6 amps and fully unwound. Do not
operate with a lead rated at less than 6 amps as this will cause premature failure of the motor which
is not covered by the guarantee.
As the colours of the wires in the mains lead of the application may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
GUARANTEE
This product is guaranteed for a period of two (2) years against faulty materials and workmanship. The
guarantee specifically excludes the use for hire or rental purposes.
Whilst every possible care is taken by Earlex to ensure that our products leave the factory in good
working order, Earlex cannot under any circumstances accept liability for problems or damage caused
by their subsequent use. Any unit that has been modified in any way or used on incorrect voltage will
not be covered by guarantee. Consumables such as filters are not covered by guarantee.
This guarantee does not affect your statutory rights.
In the event of a fault occuring please contact our helpline before returning the unit to our Service
Department at the address below together with a copy of your purchase receipt. All repairs will be
dealt with speedily.
EC Declaration of Conformity
We declare that the unit: WD1000 conforms to: 2006/95/EC, EN60335-2-2 & 2004/108/EC, EN55014-1,
EN55014-2, EN61000-3-2, EN61000-3-3, EMF EN 50366
Design Registration No. GB2069803
Tim Hopper Technical Director
British Registered Design No: 2069803
Copyright & Design Right Reserved ©
Information on the disposal of waste electrical equipment known as WEEE:
Your attention is brought to new directives applicable to the disposal of this electrical equipment,
where in accordance with the legislation this product must not be disposed of in your normal
household waste. Instead it is your responsibility to dispose of this type of waste by handing it
over to special designated collection points for recovery and recycling. This product is marked
with a ‘Wheelie’ symbol with a cross on it to remind you of this action. The objective of this
directive is to help conserve resources and ensure that it is recycled in a manner that protects
human health and the environment. For more information about where you can drop off your waste please
contact your local authority, take back facilities are free of charge.
MIN SIZE 5mm WIDE X 7mm HIGH
WD0046-04-08.qxd 21/7/08 10:54 am Page 8
