NOTE:
If you are using the unit for fine dust collection, you will need to fit the dust collection bag (WD0188) in addition
to the cartridge filter. To fit this, push the card sleeve over the inlet stub as shown below. Be careful to avoid tearing the
bag. Once the dust collection bag becomes full it should be disposed of. Spare bags are available to purchase from
Earlex, part code WDACC19.
For dry pick up
- always ensure the filter is completely dry before use.
For wet pick up
- ensure that the filter is not left submerged for longer than necessary. The combined filter supplied
is for light duty wet pick up. If you are regularly picking up wet deposits we recommend
you purchase a heavy duty combined filter from Earlex, part number WDACC13. Please
call us on 01483 454666 for more information.
12. Once the filter is fitted (and dust collection bag if required), place the motor
housing back on top of the collection bin.
13. Fit the outlet elbow to the outlet on the back of the motor housing as shown.
The outlet elbow can be used to deflect airflow from the motor away from the
work area.
OPERATION
1. Ensure that the motor housing is clipped onto the collection bin.
2. Fully unwind the mains cable and connect to the mains or extension lead.
3. The unit has three settings at switch. In continuous mode (I) the vacuum will run while
this switch is on. In power tool mode (II), switch this on and then use the power tool to
operate the vacuum. Centre position (0) is power off.
Vacuum Function
1. To use the unit for suction, fit the wider end of the hose into the inlet stub as shown right.
2. Fit the extension tubes into each other and into the hose, and attach the desired accessory
to the end of the extension tube.
3. To assemble the floor head, clip the brush/squeegee attachment into place using the
securing tabs on the sides of the head - see images A & B below.
4. Unwind the mains cable and connect to mains or extension lead.
5. Switch unit on and operate as required.
Blower Function
NOTE: Always switch the unit off before changing between vacuum and blower
functions.
1. To use the unit as a blower, fit the wider end of the hose into the outlet on the back of
the motor housing, as shown, or into the outlet elbow if convenient.
2. Always ensure that the tank, hose & accessories have been cleared of any debris before
operating the blower.
3. You should always protect your eyes with safety goggles and ensure no one else is in
close proximity.
SWITCH POSITIONS
POWER TOOL MODE
A
B
4
WD0180 0611.qxd:Layout 1 15/6/11 14:19 Page 4
