Copyright 2015 by E&G Corporation, LLC.
Visit us online today at www.egclassics.com
17
.
Remove the 8mm hex screw from the center of the factory grille air
flow shutters.
18
.
Carefully lift off the air flow shutters from the back of the factory
grille and save them for reinstallation.
19
.
For customers requesting the factory emblem installation: Remove
the 10mm speed nuts securing the factory emblem. Turn the grille
over, untape and remove the emblem for the following emblem in-
stallation procedure.
17
19
20
.
For customers requesting the factory emblem installation: Align the
powder coated emblem filler over the back of the factory emblem.
20
21
.
For customers requesting the factory emblem installation: Align the
emblem mounting plate over the back of the factory emblem, mak-
ing sure the stud bases fit through the openings in the plate and
reinstall two of the factory speed nuts.
21
22
.
For customers requesting the factory emblem installation: Align the
emblem assembly with the notches in the back of the billet grille.
Install the mounting brackets using the supplied s.s. lock washers
and s.s. #8-32 s.s. hex nuts and tighten until the emblem assembly
is snug against the billet grille fins.
22
