9
6. MANUAL
6.2 USING THE CHARGER ADAPTER
6.3.2 CONNECTING A MOBILE HOME/CAMPER COMFORT BATTERY WITH THE EYELET ADAPTER
6.3.1 CONNECTING A VEHICLE STARTER BATTERY WITH THE POLE CLAMP ADAPTER
6.3 CONNECTING THE CHARGER
Preparation
Only for open batteries
6.1 OVERVIEW
The pole clamp adapter (Position 10 in the overview) when connecting the charger in the classic way to the poles of the battery. The eyelet
adapter (Position 9 in the overview) is designed to remain firmly attached to a battery which is difficult to access. The charger can be conveniently
connected using the adapter.
Clean the battery terminals to remove dust and corrosion residue.
Remove the plugs of the battery cells. Check the liquid level in the cells, consult the operating instructions of your battery for more information.
Replenish only sufficient distilled water to ensure that the minimum filling level is achieved. The liquid will expand during the charging process
and the battery may overflow. Leave the cells of the battery open until the end of the charging process.
In case of closed and maintenance-free batteries, please follow the instructions of the battery manufacturer to the letter.
Always first connect the red plus cable (+) to the positive pole of the battery. Then connect the black minus cable (-) to the minus pole of the
battery. If you charge the battery in situ, connect the black negative cable (-) to the car body (exposed part), far away from the battery, the
carburettor and fuel lines. Always maintain this sequence.
Attach the eye of the red plus cable to the plus connection cable of your vehicle battery, e.g. the screws of the pole terminal. Attach the eye of the
black minus cable to the earth connection cable (minus cable) of your battery. Lay the cable so that it is free from bends and tensions. It may not
be attached in the vicinity of hot or rotating parts of the motor. The connection plug may not get wet.
1.
Operating control light
2.
Warning light for reverse polarity
3.
Charge status display 25 %
4.
Charge status display 50 %
5.
Charge status display 75 %
6.
Charge status display „full“ %
7.
Charging cable
8.
Mains connection cable
9.
Eyelet adapter
10. Pole clamp adapter
7
8
9
10
1
2
3
4 5
6
Figure 1: Overview
Make sure that the charger is not connected to the power socket and that the pole clamp adapter (Position 10 in the
overview) is not connected to the battery charger.
Make sure that the charger is not connected to the mains power socket and that the eyelet adapter (Position 9 in the
overview) is not connected to the battery charger.
CAUTION
CAUTION
