IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for future reference.
BEFORE USE
Inspect the product including its cable and plug
for any signs of damage. If the product is
damaged, DO NOT use it, and contact your
supplier immediately.
PRODUCT SAFETY
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance
• Not suitable for use in boats, caravans or
similar locations.
• For indoor use only
• Do not use in bathrooms, or in wet locations.
• Do not place the lead beneath a carpet or
rug.
• Do not use the appliance in locations where
paint, petrol or other flammable liquids are used
or stored.
• Do not place the lead beneath a carpet or
rug.
• Do not allow the cable to hang over the edge
of a table.
• Arrange the cable so that it cannot cause a
trip hazard.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a
qualified electrician at least once every 10 years
or at every change of occupancy.
For office and retail premises, and buildings
such as village halls, the wiring must be
inspected at least once every 5 years.
It is recommended that all building be fitted with
smoke alarms (it is mandatory for new
buildings).
INSTALLATION
Before use, check the following:
1. The voltage rating of the power supply must
be the same as the voltage rating of the
product to which it is connected.
Connecting a power supply to a product which
requires LESS voltage than the rating of the
power supply will damage the product.
A product which requires MORE voltage than
the rating of the power supply is unlikely to
work.
Use the rotary switch to select the correct
voltage.
2. The current rating of the power supply must
be equal to or greater than the current rating of
the product to which it is connected.
Connecting a power supply to a product which
requires MORE current than the rating of the
power supply will damage the power supply.
3. The polarity must be correct. The polarity
requirement of the product will be indicated, as
to whether the centre pin is positive or
negative.
This symbol means that the centre
pin is positive.
+
−
This symbol means that the centre
pin is negative
+
−
Select the correct power plug to fit the product.
Ensure that the arrow on the power supply plug
points to the correct symbol.
Connecting a product to a power supply with the
wrong polarity will damage the product.
OPERATION
Plug the power supply into a 13 A mains
socket. If using an extension lead, make sure
that it is rated at 3 Amps or greater, and that it
is fully unwound. Switch on the unit at the mains
socket.
Plug the DC power plug into the power supply
socket on the product.
PAT TESTING.
When used in an office environment, this
product must be safety-tested yearly by a
qualified electrician (PAT Tested) in order to
comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly
when used in a domestic environment.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with
domestic household waste.
Most local authorities have specific collection
system for appliances and disposal is free of
charge to the end-user.
When replacing an existing appliance with a
similar new appliance your retailer may take the
old appliance for disposal.
page 2
