Eagle Heated Drawers, Operating Manual And Instructions

Page: 4 / 8

4
instaLLation instrUctions
Remove any tape that may be holding the conduit to the unit before installing.
1
Tape
Please read the information provided under Location before determining installation site.
2
Location
Determine cutout sizes for your unit using the chart located below.
3
Level
When the proper cutout has been made, a locking strip (not supplied by Eagle) must be permanently fixed to the lower front side
of the cabinet opening.
Note: Maintain a minimum clearance of 1˝ from the bottom of the cutout to floor.
4
Locking Strip
Once the unit is installed into the opening, apply a bead of NSF-approved sealant around the drawer cabinet flanges and the location.
5
Installing
Final connections must be made in accordance with a NEC listed junction box.
6
Connections
Locate the unit in an area that is convenient for use. The location should be level to prevent the unit or it’s
contents from accidentally falling, and strong enough to support the weight of the unit and it’s contents.
a
For safe and proper operation, the unit must be located a reasonable distance from combustible walls and
materials. If safe distances are not maintained discoloration or combustion could occur.
b
Cutout Sizes for Built-In Drawer Warmers
Model Height Width Depth
DWW-1BI-120 or 240 10
7
⁄
8
˝ 29
3
⁄
4
˝ 23
3
⁄
8
˝
DWW-2BI-120 or 240 21
3
⁄
4
˝ 29
3
⁄
4
˝ 23
3
⁄
8
˝
DWW-3BI-120 or 240 32
5
⁄
8
˝ 29
3
⁄
4
˝ 23
3
⁄
8
˝
DWN-1BI-120 or 240 10
7
⁄
8
˝ 21
3
⁄
4
˝ 26
5
⁄
8
˝
DWN-2BI-120 or 240 21
3
⁄
4
˝ 21
3
⁄
4
˝ 26
5
⁄
8
˝
DWN-3BI-120 or 240 32
5
⁄
8
˝ 21
3
⁄
4
˝ 26
5
⁄
8
˝
Freestanding Units
Built-in Units
caUtion!
LEGS MUST BE INSTALLED PRIOR TO THE OPERATION OF THE UNIT.
TO AVOID DAMAGE, DO NOT LAY UNIT ON ITS FRONT OR BACK SIDE.
Install the legs into the bottom of the unit by threading them into the nut inserts and tightening securely.
1
Legs
Locate the unit in a desired area within reach of an appropriately sized electrical outlet. Consult electrical chart.
2
Outlet
Place unit on a flat, even surface and check that the unit is level both left-to-right and front-to-back. Adjust feet as
needed for a level installation.
3
Level