EAGLE
EVR-100
Operation Instructions
8
5. Use the two short M5x10 screws to screw the mounting brackets to the sides of the radio.
6. Screw each M5x32 screw through the screw hole in the mounting bracket, then attach the
stopper.
If your bulkhead exceeds 0.51” (13mm), the stopper can be discarded if necessary.
7. Tighten the M5x32 screws until the radio is held firmly against the rear of the bulkhead.
Install the Microphone Bulkhead Mount
1. Hold the microphone bulkhead mount at the
chosen location and use a soft pencil to mark
the screw hole positions on the mounting
surface.
Ensure that the microphone curly cable will
comfortably reach this location BEFORE you drill.
2. Drill the two pilot screw holes where marked.
3. Use a short length Philips screwdriver and the
set of two flat screws, spring washers, plain
washers, and nuts to secure the microphone
bulkhead mount at the location site.
4. Hang the microphone on its mount.
MM
MM
MM
MM
MM
MM
Summary of Contents for EVR-100
Page 1: ...EVR 100 VHF Radio Operation Instructions www eaglesonar com Pub 988 0158 031 ...
Page 29: ...Notes ...
Page 30: ...Notes ...
Page 31: ...Notes ...