EAGLE
EVR-100
Operation Instructions
9
Connect the Radio Cables
The connectors are on the rear of the base unit, as follows:
1.
External Speaker connector.
Plug the external speaker cable jack into the connector BEFORE
powering on the radio. Use a 4 Ohm 4 Watt external speaker.
2.
RED Power wire
. Connect this to the POSITIVE (+) battery terminal. Check that a 3 Amp fuse is
installed on this power cable close to the battery.
3.
BLACK Power wire
. Connect this to the NEGATIVE (-) battery terminal.
4.
ANT
. A radio antenna is not supplied. A suitable radio antenna must be mounted and
connected before operating the EVR-100 radio. Consult your dealer for advice if necessary.
5.
GND
. A ground connection is not usually required.
1
2
3
4
5
Summary of Contents for EVR-100
Page 1: ...EVR 100 VHF Radio Operation Instructions www eaglesonar com Pub 988 0158 031 ...
Page 29: ...Notes ...
Page 30: ...Notes ...
Page 31: ...Notes ...
