Eagle Eye Power Solutions, LLC.
VOLT METER - A 150 volt meter used to measure the line to neutral voltage on the power cable. A, B,
or C phase can be selected using the meter selector switch. The meter should read approximately 120
volts. A 150 volt or higher reading would indicate a line and neutral cable switched on the power unit or
cable.
AMMETER - A 100 amp ammeter used to measure the load being used by the load bank. It monitors
“A” phase.
FREQUENCY METER - A 55-65 HZ meter used to measure the frequency of the power unit. It should
read approximately 60HZ.
METER SWITCH - Switch used to select A, B, or C phase on the voltmeter.
RATE SWITCHES - Switch used to select the desired rate on the load bank. The rates are as follows:
1. 1 KW balanced load
2. 2 KW balanced load
3. 2 KW balanced load
4. 5 KW balanced load
5. 10 KW balanced load
6. 10 KW balanced load
POWER INDICATOR LIGHTS - These lights will light to indicate power on A, B, and C phase. All three
lights should be on.
METER TEST JACKS - This provides a place to connect an external meter. There is a test jack for
each cable pin.
POWER RECEPTACLE - The power cable from the equipment to be tested is plugged into the load
bank through the receptacle.