Eagle Eye Power Solutions, LLC.
GENERAL SERVICE
There is no regular maintenance required on the load bank. There are no adjustments inside the load
bank. It should however be checked periodically for defective fans, burned out light bulbs, and defective
meters.
To remove the fan panel, remove the screws around the outer edge.
The meters can be removed and replaced from the front panel.
The fan grills should be kept free of any trash.
Do not place any objects in the fan or resistor grill.
FAN REPLACEMENT
The following are steps to take to replace a defective fan.
1. Remove the screws holding the fan panel to the load bank.
2. Remove the four wires on the terminal strip comming from the load bank
3. Drill out the rivets holding the fan (four on each side).
4. Lift up the fan and unplug the wire to the fan. Plug the new fan into the wire and put the
fan back on the fan panel.
5. Rivet the new fan back to the fan panel.
6. Place the fan panel back on the load bank. Make sure that the wires are on the proper
terminals.