APPENDIX 3 PUSH VIDEO CONFIGURATION
86
Alarm sensor connection
Connect the alarm sensor, such as magnetic contacts, to the PUSH VIDEO alarm-in terminal or I/O pin which
supports Push Video on the DVR rear panel.
A3.2 Configuration
Before configuring Push Video, make sure:
1. The DVR system is set up as described in “2. CONNECTION AND SETUP” at page 4.
2. The DVR is connected to Internet.
3. You’ve installed the app, EagleEyes, on your iPhone, iPad or Android mobile devices.
For details, please refer to “APPENDIX 4 MOBILE SURVEILLANCE VIA EAGLEEYES” at page 88.
Step1: Right click to show the main menu.
Go to
(ADVANCED CONFIG.)
"NOTIFY” to enable “GUARD” to “ON”, and configure your alarm
sensor type (N.C. or N.O.).
ADVANCED CONFIG
CANERA
PUSH VIDEO
PUSH STATUS
MESSAGE MAIL
VIDEO MAIL
DETECTION
GUARD ON
ALERT
CH01
ALARM OFF / INTERNAL ALARM
CH1
NETWORK
CH02 ALARM
OFF
CH2
DISPLAY
CH03 ALARM
N.O.
office
RECORD
CH04 ALARM
OFF
CH4
DEVICES
DCCS
IVS
NOTIFY
EXIT
Step2: Open EagleEyes, and add this DVR to the EagleEyes address book.
Note:
For more details about EagleEyes operation, please visit
www.eagleeyescctv.com
.
Step3: Enable Push Video as described below, and try to trigger your sensor to see if you can receive Push Video
successfully.