CONNECTION AND SETUP
5
2-2 To install on the second bracket
Align the screw holes of the bracket with the hard
disk’s screw holes. Make sure the PCB side of the
hard disk is facing up. Then, fasten the hard disk to
the bracket.
fasten
Step3: Replace the first bracket back to the DVR.
Step4: Connect the power and data bus cables to the hard disk.
Step5: Close the upper cover of the DVR, and fasten all the screws you loosened in Step1.
Type 2
Note:
Below takes a 16CH DVR model as an example. This hard disk installation type may also appy to a
8CH or 4CH DVR model.
Step1: Loose the screws on the upper cover and open the upper cover of the DVR.
Note:
The DVR cover is made of metal. Please be careful with its edge when you remove the cover.
Step2: Find the HDD brackets supplied in the sales package, and also the screw holes in the DVR as indicated
below.
Note:
One hard disk should use two brackets.
Front Panel
Rear Panel
screw hole for
hdd bracket