©
EAE Technology
www.eaetechnology.com
Page 13 / 21
Product Manual MD
100
EAE KNX Presence Detector
MD
100
PM R
1.0
Slave
: Slave sensors only deliver presence information to the master in order to extend
detection zone of master sensor.
Number of slave
*no slave
1
2
3
4
If detector mode is selected as master, parameter will be visible. “Presence slave 1…4” objects will be
created according to number selected.
Enable presence
*yes
no
Parameter enables/disables presence parameters and objects.
Enable temperature
*no
yes
Parameter enables presence parameters and objects.
Enable brightness
*no
yes
Parameter enables brightness parameters and objects.
Enable HVAC
*no
yes
Parameter enables brightness parameters and objects.
Overwrite settings for download
* yes
no
This parameter is used to decide whether settings stated below are overwritten or not by
downloading application to the device.
Presence
: stay on time, delay time
Constant light control : stay on time, delay time, set point, calibration value
HVAC
: stay on time, delay time
Device alive operation active
yes
*
no
This object is used to report that device is still alive and connected to KNX line. (Heartbeat) If alive
telegram is not received, device may be defective or KNX cable can be disconnected. If parameter is
selected “yes”, following parameters come up.
In operation value
*
send value “0”
send value “1”
Telegram value can be selected as “1” or “0”.
Operation send interval [sec]
1…*
300
…65535
Telegram value is sent cyclically according to time interval.
