Installation, Operation and Parts Manual
EE62C-35T-E / EE62C-42T-E
23
OPERATION INSTRUCTIONS
5.1 Precautions
·
ONLY authorized persons are permitted in the lift area.
·
Do not try to raise the vehicle with excessive length or width. Otherwise there is risk of vehicle falling from lift.
·
Inspect the space above and below the load and the loading carrying devices. It shall be free of obstructions before operating.
·
Before raising operation, run the lift without load for a complete cycle to ensure it is in good condition.
·
Before lifting the vehicle and during all operations on the vehicle, make sure that it is properly stopped by the hand brake.
·
Check the vehicle after raising a short distance to ensure that it is correctly and safely positioned.
·
It is forbidden for people to stand in the field of motion during raising or lowering movement.
·
The load carrying device shall be observed by the operator throughout the motion of the lift.
·
Engage the safety locking mechanism before entering under the raised vehicle.
·
Avoid excessive rocking of vehicle while on the lift
·
Always use safety stands when moving or installing heavy components.
·
Do not climb onto the load or load carrying device when they are raised.
5.2 Operation instructions
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift the
vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle adapters. The lift must be only used in
a static position for lifting and lowering vehicles.
Only one operator is allowed to work around the vehicle lift.
Always engage the safety locking mechanism before any operation on the lifted vehicle.
Do not make any operation on the lifted vehicle at a height under the first latching position (less than 500mm).
Never attempt to lower the lifted vehicle to the bottom when any of its wheel is removed unless you are assured that no
damage will occur.
Pos.
Descriptions
Function
QS
Power switch
Control main power
HL
Power indicator
Show if electricity is connected
SB1
UP button
Control the rising movement
SB2
Safety lock button
Engage the mechanical safety lock
SB3
DOWN button
Control the lowering movement
SB4
APS button
Use together with SB3 for direct descent
