EAE EE-6435V2.S, Installation, Operation, And Parts Manual

Page: 21 / 51

Installation, Operation and Parts Manual
EE-6435V2.S/EE-6435V2.B
21
Step 6: Fit on 8 nylon sliders and 4 protection covers.
1. Fasten the slider to its holder and then connect the slider holder and the cross beam.
2. Fix protection covers.
Step 7: Fix the drive-on ramps.
Align the end of the platform and the hole on the ramp and connect them with shaft and cotter pins.
Step 8: Fit on four post caps on top of the four posts.
Step 9: Connect the electrical and hydraulic system.
Refer to electrical and hydraulic connection diagrams before making connection.
Attention: electrical system connection must be done by licensed technicians. (For three phase power supply, if the lift doesn't raise and the
motor may turn in the wrong direction, in such event, interchange wires U, V in the control cabinet).
Step 10: Fill with hydraulic oil.
ONLY CLEAN AND FRESH OIL ONLY .Lift must be fully lowered before changing or adding hydraulic oil.
Pour 10 liters anti-abrasion hydraulic oil into the oil tank. The level of oil shall reach the tippets volume mark of the tank.
Run the lift for several cycles and add more oil until the lifting platform can reach its maximum height.
Note
：
It is recommended to use NO.46 hydraulic oil when average temperature of the location is above 18 degree Celsius and using NO.32
hydraulic oil when temperature is below 18 degree Celsius.
Change the oil 6 months after initial use and change once per year thereafter.
Step 11: Levelling
Attention: No vehicle on platforms when levelling.
Firstly, level the platforms when mechanical safety locks are disengaged.
Switch on and press the UP button when the green power indicating light is on. When the steel cable has been tightened, measure if the two
platforms are of the same height from the ground with a leveling pipe. If not, adjust screw ② fixed on top of the power side post.