Assembly Instructions:
Step 1:
Please make sure to read all the assembly instructions before starting your project.
Step 2:
Identify all your brackets so you know which bracket goes where. The diagram below shows which bracket
is used for which area of your project.
Please note: When assembling make sure brackets are facing the directions shown in this diagram.
Step 3:
Measure and cut your lumber. Cut your lumber using a skill or table saw. All cuts are straight cuts – no
angle cuts. If you are not a saw person – many local and main chain lumberyards will cut your lumber for you for
free or a minimal charge. Cut your lumber as follows:
Note: As you measure and cut your lumber (done easily with a chop saw), please make sure you label each piece
with the corresponding letter on your lumber cut list as this makes it easier to tell apart and assemble later. Wait to
cut boards H, E and G until structure is complete to adjust door as needed.
Out of an 8’ piece of lumber cut:
A = (22 ea) at 5’ – 5 9/16"
B = (11 ea) at 7’ - 0"
C = (22 ea) at 5' – 10"
D = (4 ea) at 4’ - 10"
H = (4 ea) at 6’ – 1 3/4"
K= (6 ea) at 6' – 1 1/4"
M = (10 ea) at 7’-0”
N = (5 ea) at 6’ – 0”
Out of remaining lumber cut:
E = (4 ea) at 2’ – 2 1/2"
G = (6 ea) at 2’ – 1 1/4"
L= (8 ea) at 2’ – 71/2”
