Step 8:
Assemble the front of your structure. Do not add screws until you have everything adjusted how you would
like them. First add your K boards by sliding in the T brackets and adding the studs. Then build your door assembly.
Attach your door assembly using the hinges you purchased. Attach hinges to the K boards so the doors swing
together like barn doors. There may be a small gap on either side of the door – this is designed so that if you
purchase a non-flush hinge – the door will still open and close. If you do not wish to have a gap, you can cut your
door assembly boards slightly larger for that or adjust the K boards to compensate. Finally measure and cut your E
boards – these might be a slightly different length if you have adjusted the door assembly or K boards at all.
Securely fasten everything with screws once you feel everything is adjusted and in place how you would like it.
Please see the front elevation diagram below.
Step 9:
Finally – measure your structure to determine the amount of materials you will need to purchase to cover
your structure. Always make sure you allow for seams or waste material and purchase extra. To determine the
