E-Tech VPPH01 Manual
16
Note
The E-Tech VPPH01 IP phone supports saving 127 entries unanswered call, dialed call and received call
ranged from 0-126 at best.When the entries arrives 127, the latest record will cover the first one. The record will be
lost when the phone restarts or turned on.
7.0 Usage of the phone
Receiving calls:
The E-Tech VPPH01 phone can receive incoming calls from other VPPH01 phone and devices that support the H.323
protocol. It works just like an ordinary phone for incoming calls. When it rings, you can receive the call by following
methods:
1. Use handset: Lift the handset and begin speaking. When the call is over, put the handset back.
2. Handset to hand free: While receiving call with handset, press speaker on the keypad and then put down the
handset. When the call is over, press speaker again.
3. Hand free: Press speaker to speak to the other party. When the call is over, press .again.
4. Hand free to handset: While receiving the call with speaker pressed, pick up the handset to continue the call. When
the call is over, put back the handset.
Note
When you communicate with the other party without lifting the handset, please do not exceed 40 CM
from speaker.
Place a call
Call another VPPH01 phones under the same Gatekeeper:
Handset:
Pick up the handset and listen for the Internet dial tone. Then dial the phone number you wish to call and
press # or Call to end the dialing. Once the call connection has been established and the ring tone has sounded, wait
for the other party to answer. When the other party answers, you can begin speaking. When the call is over, put back
the handset. The
dialed number has been saved into the buffer.
Hand free
: Press Hand free and listen for the Internet dial tone. Then input the phone number you wish to call and
press # or Call to end the dialing. Once the call connection has been established and the ring tone has sounded, wait
for the other party to answer. When the other party answers, you can begin speaking. When the call is over, Press
Hand free again. The dialed number has been saved into the buffer.
Blind dialing
: Use the keypad to enter the phone number you wish to call and then press # or Call to make the call.
Once the call connection has been established and the ring tone has sounded, wait for the other party to answer.
When the other party answers, you can begin speaking. When the call is over, Press Hand free again. The dialed
number has been saved into the buffer.
Place a call without login the Gatekeeper
If The E-Tech VPPH01 IP phone does not login the Gatekeeper, you can place a call by lifting the handset or pressing
Hand free and then inputting the IP address of the other party, and then pressing # or Call
Place a call through Gateway
If The E-Tech VPPH01 IP phone does not login the Gatekeeper, you can place a call through Gateway directly by
lifting the handset or pressing Hand free and then inputting the IP address of the other party, and then pressing # or
Call
Note
When you place a call without Gatekeeper or with Gateway, please log off Gatekeeper. To get the
detailed operation please refer to Configuration chapter.
View Records
View missed calls
Click missed call keypad
¯
then you will hear the record of missed call. Click Vol/+ keypad to turn the numbers orderly;
click Vol/- to turn the numbers reservedly. If there is no record, you will hear nothing.
View answered call
Click answered call
¯
then you will hear the record of the received call. Click Vol/+ to turn the number orderly; click Vol/-
to turn the numbers reservedly. If there is no record, you will hear nothing.