E-Swin E-one, User Manual

Page: 14 / 25

27 26
• Shot emission
- To be able to emit shots the glass applicator tip
(light guide) must be placed on the skin. Pressure
must then be applied so as to snap on the appli-
cator head.
- Shot emission can then be triggered by pressing
the button on the side of the applicator.
- Pressure must then be released for the applica-
tor to come away from the skin.
- The applicator is then moved to an adjacent
area. The next shot may only be applied once the
LED is green (if the applicator is applied before
the LED turns green, no shot will be emitted).
Observation: Each time a shot is emitted the area epi-
lated is the area covered by the light guide tip, 3 x 2 =
6 cm_. Upon releasing the pressure on the applicator,
a slight imprint can be seen in the gel enabling you to
see where you are up to.
The glass surface (light guide) at the tip of the appli-
cator must be placed flat on the skin.
13 14
20
15 16
17
18
The applicator must only be used once the
green light is on (if the applicator is pressed
to the skin too early (before the green light
comes on), no shot will be emitted.
- Take care to stretch the skin in those areas in
which it is finest to ensure that the glass part of
the applicator tip (light guide) comes into contact
with the skin and that hair is removed correctly
from the treated area.
❙
STEP 5
END OF THE SESSION
• Press button 15.
• You may unplug the E>One from the mains once the fan
has switched off (after approximately 10 minutes).
• Clean the glass applicator head (light guide) with a
damp cloth.
• Finish cleaning with the Clean spray
(photos 19 and 20).
If you wish to clean the after use, you
must wait until the applicator fan has stopped
before unplugging the base. This enables the
optical parts to cool down fully.
• Store the in a suitable place.
Observation: If you have sensitive skin, do not use a
depilatory cream on the treated areas for one week
after depilating with the
HAIR REMOVAL WITH THE ______
19