2. Vibration Speed, Beep Volume and Number of Beeps
Vibration Speed (1 = low, 2 = medium, 3 = high), Beep Volume (1-3), Number of beeps (1-6).
(Factory settings are Vibration = 3; Beep volume = 3; Beep number = 3)
1. Time, Date and Daylight Saving Settings
The e-pill Vibrating Pager Reminder will automatically adjust the time for daylight savings
time; please see details below on how to turn this feature on or off).
(
TIP
: Hold Set button
down to rapidly advance counting).
6
e-pill
®
Vibrating 12 Alarm Pager | www.epill.com
15
Q&A
e-pill
Vibrating 12 Alarm Pager
1. The Unit appears stuck in the Timer or Meeting Timer:
try pushing the two
middle buttons simultaneously (just for a second) until the display blinks, and then
press the mode button to exit. To EXIT the Custom Timer, press and hold the two
middle buttons for 2 seconds.
2. The Meeting Timer does not appear to be working:
The Meeting Timer does
not show countdown when in operation. It only shows "ON" and the total time of
the meeting or interval set.
3. No alert is vibrating for the Meeting Timer:
Make sure you have a meeting
time set & the Meeting Timer is ON; the display should show for example: “ON
00:45” . Also, make sure the vibration switch on the side of the unit is set to “V” for
vibration.
4. The vibration strength is not strong enough:
Try setting the vibration to “3,
high”. See “1. How to set vibration speed…” on page 6. You can also try to change
battery. Make sure to use an alkaline battery. Note: The e-pill Vibrating Pager will
retain your programming for a short time (30 seconds to 1 minute) while you change
your battery. See “Care of your Vibrating Pager…” on page 3.
5. Alarms do not appear to organize correctly when setting multiple alarms:
The unit automatically organizes the set alarms in the order of next to go off. So
when you set or check your alarms, the unit will display Alarm 01 as the next to sig-
nal, and Alarm 02 as the next after that one and so on.
6. You cannot enter the Alarms mode to set alarms:
Hold down the Enter button
for 3 seconds to enter the Alarms mode (this protects alarms from accidental erasure.
7. The vibration is too long for the Timer and Alarms:
Vibrations in these modes
= 20 seconds. To stop the vibration, push any button. In the Alarms mode, one push
of the "Lite" button stops the alert and also engages the snooze feature, and an alert
will signal again in 5 minutes.
8. Can I set alarms with the stop watch:
The Stopwatch cannot be used to set an
alarm.
9. When do I change the Battery:
The battery is low when the backlight becomes
dim and the vibration is noticeably slower / or the beep volume is lower. The e-pill
Vibrating 12 Alarm Pager will retain your programming for a short time (30 seconds
to 1 minute) while you change your battery.
e-pill
®
Vibrating 12 Alarm Pager | www.epill.com
