18
BEFORE EACH USE
REMOVING HAIR WITH
1
2
3
•
Check the power cord (must not be pinched or crushed, wire must not be bare).
•
Check the cable connecting the base to the applicator (no visible impairment).
•
Check the external optical parts of
.
> Check that the glass tip of the applicator (optical guide) is intact, and if this is not the case (if the opti-
cal guide is cracked or chipped), changing the whole mobile head is essential. Ordering this part is possible at
www.e-swin.com * (go to “Customer Centre “, “New Order of accessories” then “mobile head applicator”).
•
Verification and maintenance of the internal optical parts.
- In all cases, the device must be unplugged before you start disassembling the mobile head.
- Before each use, and before plugging-in the
, you must check the integrity of the internal optical parts: tube,
filter (flat red piece of glass), and optical guide. The filter must be cleaned systematically before each hair removal
session with the
. It must be clean and free of dust.
To proceed to the verification code:
> Press simultaneously on the 2 locking tabs of the mobile head, and remove it (
1
).
> Delicately place the mobile head on a flat surface.
Once you have completed your treatment, you must wait for the fan to come to a complete stop (it
may take more than 10 minutes), before switching it off and unplugging it. This procedure enables the
internal optical parts to cool down.
The other fans, located in the base of
, will only stop once
the device is unplugged.
VERIFICATION
S
S
S
S
Summary of Contents for clinic
