E-MORE 2M2S TQD, Operation Manual

Page: 15 / 18

13
E-MORE 2M2S / 2M3S TQD
Before using this device, read these operating instructions carefully and keep this user manual for future reference.
Before using the product, check the desk and power cables for any visible sign of damage. If you notice cuts and deep
scratches, do not turn on the device.
Before connecting the product to the power supply, make sure that the power supply voltage is compatible with the parame-
ters of the product.
Before using it, make sure that the length of the power cable allows you to connect the desk to the power supply
The height-adjustable desk contains electronic circuits and should only be used in dry environments. Do not use outdoors or
in very dusty environments. Keep away from heat sources and any corrosive materials.
Keep all electrical components away from liquids. Never touch or handle the desk, power supply, the control box, the panel
control, or any other cable with wet hands.
Clean the product only with a clean, dry,soft cloth or cloth. Disconnect from the power supply before moving or cleaning elec-
trical components.
Do not disassemble the columns, control box and control panel. These actions are considered damage cause by the user.
This product contains small parts. Make sure they are out of reach of children. Do not allow children to play with the device.
Packing materials must not be used as toy.
Do not lay or sit on the worktop. This product is not for lifting people.
Do not exceed the maximum permissible load weight.
This product can be used in a 10% cycle (2 minutes of operation, followed by 18 minutes pause).
The manufacturer cannot be held liable or responsabile for any damage or injuries resulting from improper use of the height
adjustable desk, in other words, non-compliance with these safety instructions and warnings.
IMPORTANT SAVETY INSTRUCTIONS
TROUBLESHOOTING
Error Code Possible Cause How To Correct
E01, E02 Cables are not connected or broken
the weight of the desk exceeds 120 kg Connect cables properly, if problem persists change engine
Remove weight from desk
E06 Lifting columns out of synch Perform a reset as described under RES.
E07 Loadweight exceeds 120 kg Remove weight from desk
E08 Input voltage lower than required Improve the input voltage
E09 Input voltage higher than allowed Lower the input voltage
E10
Control panel is not connected or does not
receive power Wait 1 second for the error code to disappear
If it persists check the connection cables
RES
Reset is required
Hold the "Down"-Button for a while. The desk will lower to the
minimum height.
HOT
Excessive use Do not use for 18 minutes. System will recover automatically.