E-MORE 2M2S TQD, Operation Manual

Page: 17 / 18

15
E-MORE 2M2S / 2M3S TQD
7. Setting the new lowest display and height range (7SH)
The desk frame ships defaulted to its minimum and maximum height limits. These steps allow the upper and lower limits to
be adjusted to your preference:
Press
S
button and hold for 3 seconds, handset display . Release
S
button, press
S
button again to enter, it displays
.
Press UP or DOWN. It will display 7FS.
Press
S
button to enter. It will display , press UP or DOWN. It will display and .
: Sets the lowest position height display.
:Sets a new minimum desk height
:Sets a new maximum desk height
Press UP or DOWN. It will display , press
S
button to enter. It will display the current lowest height. Press UP or DOWN
to set the lowest height display, press
S
to confirm .
Press UP or DOWN ,It will display . Press
S
button to enter. It will display the current lowest height. Press UP or DOWN
to set a lowest height position, press
S
to confirm .
Press UP or DOWN ,It will display . Press
S
button to enter. It will display the current highest height. Press UP or DOWN
to set a new highest height position, press
S
to confirm .
8. Setting Constant-touch & One-touch for go Up or Down (8Hc)
Press
S
button and hold for 3 seconds, handset display . Release
S
button, press
S
button again to enter, it displays
.
Press UP or DOWN. It will display 8Hc.
Press
S
button to enter. It will display current mode . Press UP or DOWN, it will display .
: Keep pressing UP or DOWN button to make the desk move up or down.
: Press UP or DOWN button and release, the desk will be moving up or down automatically; Press any button to stop the
desk when it's moving.
Press
S
to confirm your preference, wait 2 seconds, setting is saved.
9. Reminder setting (9St)
To get a healthier working style, the desk can remind you to stand up when you sit for a long time. You can set it by doing the
following:
Press
S
button and hold for 3 seconds, handset displays . Release
S
button, press
S
again to enter, it displays .
Press UP or DOWN go to display 9St.
Press
S
to enter. It will display
. 0.0 is the standard and means no time reminder (H means Hour).
Press UP or DOWN to select the time reminder you want, ( means 1.5 hours), press
S
to confirm.
Note: When the handset time reminder beeps, press any button to make it disappear; the time reminder will last for 30 se-
conds if no buttons are pressed.
10. Setting bounce height (10H)
Press
S
button and hold for 3 seconds, handset display . Release
S
button, press
S
button again to enter, it displays
.
Press UP or Down to display 10H.
Press
S
button to enter. It will show the current bounce height.
Press UP or DOWN to get the bounce height. Press
S
to confirm, wait 2 seconds, it will display the current height.
11. Restore Factory Defaults (11r)
Press
S
button and hold for 3 seconds, handset display . Release
S
button, press
S
button again to enter, it displays
.
Press UP or DOWN to display 11r.
Press
S
to enter. It will display
and flash.
Press
S
to confirm, wait 2 seconds, it will display the current height.
12.Fatigue test mode (d)
Factory use, please ignore this programming.