E-MORE 2M2S TQD, Operation Manual

Page: 16 / 18

14
ENGLISH
1. Display units (1Un)
Change the numeric display to show height in either inches or centimeters.
Press
S
button and hold for 3 seconds, handset displays . Release
S
button, press
S
button to enter, it displays .
Press
S
button again to confirm the first programming setting.
It will display . Press
S
button to get CM display, wait 2 seconds, centimeters setting is done. It will display current height
(cm)
After it display , press UP or DOWN. It will display , press button
S
, wait 2 seconds, inches setting is done. It will
display current height (Inch)
2.Handset display brightness (2br)
Press
S
button and hold for 3 seconds, handset displays . Release
S
button, press
S
button to enter, it displays .
Press UP/Down, it will display 2br.
Press
S
to enter, it will display current brightness level
: Means normal brightness | : Means low brightness | : Means high brightness
Press UP or DOWN to select the desired brightness level, press
S
button to confirm, wait 2 second. It will display the current
height.
3. Setting voice (3bE)
Press
S
button and hold 3 seconds, handset displays . Release
S
button, press
S
button again to enter, it displays
.
Press UP or DOWN. It will display “3bE”
Press
S
button, it will display current sound status , or .
: Means no voice when you press the button | : Means with voice when you press the button.
Press UP or DOWN to select or , then press
S
to confirm, wait 2 seconds. It will display the current height.
4. Go up anti-collision sensitivity (4Fu)
The desk has an Anti-Collision Sensitivity that will stop the desk’s movement if it hits something on the way up. You can
change this sensitivity level by doing the following:
Press
S
button and hold for 3 seconds, handset displays . Release
S
button, press
S
again to enter, it displays .
Press UP or DOWN. It will display 4Fu.
Press
S
button to enter. It will display the current anti-collision sensitivity level. There are 9 levels for up from
to ;
is the most sensitive setting, is the least sensitive setting.
Press UP or Down to select the your favorite level. Press
S
button to confirm, wait 2 seconds, it will
display the current height.
5. Go down anti-collision sensitivity (5Fd)
The desk has an Anti-Collision Sensitivity that will stop the desk’s movement if it hits something on the way down. You can
change this sensitivity level by doing the following:
Press
S
button and hold for 3 seconds, handset displays . Release
S
button, press
S
again to enter, it displays .
Press UP or DOWN. It will display 5Fd.
Press
S
button to enter. It will display the current anti-collision sensitivity level. There are 9 levels for down
From to ;
is the most sensitive setting | is the least sensitive setting.
Press UP or Down to select your favorite level. Press
S
button to confirm, wait 2 seconds, it will display the current height.
6. Balance sensitivity (6FS)
The desk has a balance sensitivity to make sure the 2 columns always work in the same position . You can change this Sensi-
tivity level by doing the following:
Press
S
button and hold for 3 seconds, handset display . Release
S
button, press
S
button again to enter, it displays
.
Press UP or DOWN. It will display 6FS.
Press
S
button to enter. It will display the current balance sensitivity level. There are 9 levels for down from to ;
is the most sensitive setting | is the least sensitive setting.
Press UP or Down to select your favourite level. Press
S
button to confirm, wait 2 seconds. It will display the current height.
ADVANCED PROGRAMMING