E-Lins WAP100 Series Outdoor AP Quick Start
E
‐
Lins
Technology
Co.,Limited
Tel:
+86
(755)
33231620
E
‐
mail:
sales@e
‐
lins.com
www.szelins.com
network.
In Repeater mode, the access point acts as a relay for network signals on the network by regenerating
the signals it receives, and retransmitting themto main network infrastructure.
Detailed information on the Repeater mode is available in the Repeater Setup
section.
** Note: Repeater WDS requires the access point to be setup in RootAP or
Access Point WDS mode to work.
2 Installation
2.1 Setup requirements
Before starting, please verify that the following is available:
CAT5/5e networking cable
At least 1 computer installed with a web browser and a wired or wireless network interface
adapter.
All network nodes installed with TCP/IP and properly configured IP address parameters.
2.2 Hardware installation
The access point can be powered using the 802.3af standard PoE Injector. This accessory supplies
operational power to the wireless access point via the Ethernet cable connection.
Step 1:
Use an RJ45 Ethernet cable to connect one end of the cable to the Ethernet socket of the
Injector and the other end to one of the LAN ports of the accesspoint.
Warning:
When one port is used for PoE, the other port cannot connect to any other network device.