FT
-3
0
5.10.01
© E.L.B. Ex-Geräte Bachmann
Rev. 1.9 Page 5
Cordless Keyboard
The EEx-Keyboard uses two AA alkaline batteries (Duracell Alkaline-Batteries type
MN1500). It's not allowed to use other types of batteries.
1.
Remove the battery compartment cover outside
the Ex-area on the bottom of the Cordless
Keyboard.
To remove the cover, squeeze the cover
in from the tab to release it..
2.
Place the flat end (negative pole) of one AA
battery against the spring, then insert the next
battery as shown.
A diagram in the battery
compartment shows the correct battery installation.
3.
After the batteries are installed, carefully put the cover back into place.
Battery Warning – Important!
When battery power is low for the
mouse or keyboard, the
MouseWare’ software displays a
dialog box under Windows’
95/Windows’ 98 and Windows
NT’4.0 suggesting that you change
the batteries. It is recommended
that when you change batteries
you change them for the mouse
and keyboard at the same time to
optimize performance. When
replacing the batteries, use only
Duracell alkaline batteries. Note
that the battery level indicator in
the Cordless tab of the Keyboard
Properties or the Mouse Properties
is calibrated for Duracell alkaline batteries only.
Discard all used batteries according to the battery manufacturer’s instructions.
Exercise care when handling batteries. When batteries are misused, they may
explode or leak, causing burns and personal injury. Do not open a battery or
mutilate, dispose of in a fire, expose to heat above 212° F (100° C), immerse in
water, install improperly, or recharge. Conducting materials, such as rings,
bracelets, and keys, can short out a battery causing it to overheat and possibly
leak or explode. When you are not using your
cordless device for long periods of
time, remove the batteries and store them in a dry place at normal room
temperature.
