Charging the Battery
NOTICE:
Charge only batteries that are cool to the
touch and are not damaged. Look at the battery to
make sure it is not damaged e.g., swollen, bent,
broken or punctured.
CAUTION:
Only use chargers specifi cally
designed to charge the included Li-Po
battery. Failure to do so could result in fi re,
causing injury or property damage.
CAUTION:
Never exceed the recommended
charge rate.
1. Insert the charger into a USB port. The charger
only uses power from the USB port, it will not
connect to your computer. USB power supplies,
such as those used to charge cellular phones,
can also be used.
2. Slide the battery into the slot on the charger and
press it into the charge jack/connector located at
the bottom of the slot. The end cap of the battery
is specifi cally designed to allow the battery to fi t
into the slot one way (usually with the label on
the battery facing outward) to prevent reverse
polarity connection. However, check for proper
alignment and polarity.
3. Always disconnect the fl ight battery from
the charger immediately upon completion of
charging.
4. Remove the charger from the power supply.
LED Indications
When you make the connection successfully, the
LED on the charger turns solid red, indicating
charging has begun. Charging a fully discharged
(not over-discharged) 70mAh battery takes
approximately 30–40 minutes. The light goes out
when the charge is complete.
CHARGING
(Solid Red)
MAX CHARGE
(OFF)
CAUTION:
Once charging is complete,
immediately remove the battery. Never
leave a battery connected to the charger.
5
EN