Available from:
www.modelflight.com.au
8. Locate the 4" (102mm) linkage wire. Slide the
“Z” bend into the center hole of the elevator
control horn. Pass the linkage through the
pushrod connector on the servo arm. Turn on
the radio and plug the elevator servo into the
receiver. Center the elevator trim and stick, and
check that the sub-trim (if a programmable radio)
has been set to 0. Install the servo horn back onto
the elevator servo. Use a 2mm x 4mm screw to
secure the linkage.
9. Repeat Step 7 for the rudder linkage.
23
