20
E-flite Leader 480 ARF Assembly Manual
3. Insert the hinges in the rudder (or elevator).
The T-pin will rest on the edge of the bevel of the
control surface.
4. Slide the rudder (or elevator) into position. Make
sure the tip of the control surface is aligned with the
tip of the fixed surface.
5. Saturate each hinge with thin CA. Apply CA to
both side of the hinge.
Do not use CA accelerator when gluing the hinges.
The CA must be allowed to soak into the hinge for the
best bond between the hinge and surrounding wood.
6. Once the CA has cured, gently pull on the control
surface and fin to make sure the hinges are glued
securely. If not, apply CA to those hinges that are not
glued and recheck.
7. Move the rudder through its range of motion a
number of times to break in the hinges. This will
reduce the initial load on the servo during your
first flights.
8. Pass the Z-bend in the rudder (or elevator) pushrod
through the outer hole of the control horn.