4. Slide the aileron and wing together. Remove
the T-pins. There should be a 1/64" (.4mm) gap
between the aileron and wing. Make sure the
aileron can move freely without binding.
Note
:.The.aileron.has.a.block.installed.for..
the.aileron.control.horn.to.mount.to..Make..
sure.this.block.is.located.on.the.inboard.side..
of.the.wing.
5. Deflect the aileron and apply thin CA to
each of the hinges. Make sure to saturate each
hinge. Apply CA to both the top and bottom
of the hinges.
Note
:.Do.not.use.accelerator.in.the.hinging.
process..The.CA.must.be.allowed.to.soak.into.
each.hinge.naturally.
20
