6
E-flite Habu 32 EDF ARF Assembly Manual
4. Use 5-minute epoxy to glue the
control horns into the holes for the flap and aileron.
Use a square to make sure the control horn is
perpendicular to the control surface. Also check
again to make sure the hole in the control horn is
directly over the hinge line.
5. After around 3 minutes, before
the epoxy cures, carefully remove the tape from
around the control horns. Pull the tape away from
the horn, being careful not to disturb the position of
the control horn. This will allow the epoxy to flow
out slightly, leaving a fillet between the control horn
and control surface.
6. Repeat Steps 1 through 5 to install the
remaining aileron and flap control horn.
7. Sand a slight angle on the fiberglass control
horn for the elevator. This is so the top of the horn
does not distort the covering on the top of the
elevator. Test fit the fiberglass control horn in the
slot in the elevator, making sure the horn does not
distort the covering on the top of the elevator.
8. Repeat steps 1 through 5 to glue the control
horns in both elevator halves.
9. Repeat steps 1 through 5 to glue the control
horn in the rudder.